Doepfer A-190-1 MIDI-CV/Gate/Sync Interface Instrukcja Użytkownika Pobierz pdf (Strona 20)

A-190

MIDI-CV/SYNC interface

System A - 100

doepfer

4.6 Initialisation (Reset)

When the A-190 is first switched on after leaving the

factory, its memory is initialised - that is, all parame-

ters are set to their standard default values (see the

table on page 21).

You can always perform a reset, and return the A-190

to these

standard factory settings

. There are two

forms of reset available:

a. Only the parameters marked "







" in the table

are reset.

All the parameters in the table are reset.

For partial reset ‘a’, do the following:

Switch the System A-100 off.

Keep the menu button

pressed, while turning the

A-100 power back on.

The A-190 will confirm the partial reset by flashing

all its LEDs (

)

slowly

for about five seconds.

For the full reset ‘b’

, do the following:

Switch the System A-100 off.

Press and hold buttons

, while turning the

A-100 power back on.

The A-190 will confirm the full reset by flashing all its

LEDs

slowly for about five seconds, then quickly

for another five seconds.

1 2 ... 15 16 17 18 19 20 21 22

Brak uwag

Doepfer A-190-1 MIDI-CV/Gate/Sync Interface Instrukcja Użytkownika Strona 20